Air Lift LoadLifter 7500 XL, Руководство по установке

Страница: 18 / 28

MN-1033
16
12 . Figure D .35 shows the assemblies complete and ready to install .
ATTACHING THE ASSEMBLIES TO THE FRAME
1 . Drop the axle or raise the frame to make room to put the assemblies into position .
2 . Set the driver’s (left) side assembly onto the jounce bumper strike plate (Fig . D .36) .
Make sure the 3/8"-16 x 10" carriage bolt (DD) on the bottom bracket goes
outside the hard brake line on the back side of the axle . Raise the axle just enough
to insert the 3/8"-16 x 2" carriage bolt (M) (that is installed in the upper bracket)
through the existing jounce bumper hole in the bottom of the frame . At the same
time, line up the upper brace into the remaining two carriage bolts in the assembly’s
upper bracket (Fig . D .37) . Do this just enough for the carriage bolts to hold the
assembly into postion in the frame, while resting on the jounce bumper strike plate
(Fig . D .36) .
fig. D.35
The long carriage
bolt must go
outside the hard
brake/ABS line on
the driver’s (left)
side .
Raise the axle up
while aligning the
3/8"-16 x 2" carriage
bolt (M) through the
frame and the two
3/8"-16 x 1 1/4"
carriage bolts (O) in
the upper bracket,
through the brace .
Existing
jounce
bumper
strike
plate
fig. D.36
fig. D.37
O
Driver’s
(left) side
assembly Passenger’s
(right) side
assembly
LoadLifter 7500 XL
16