6.2.2 Cyclic Output/Storage of all Measuring Points
The print cycle (see 7.2) must be programmed for cyclic outputs of measured
values (see man. 6.5.1.2) and recording. The measurement can be started
using the key <START> and stopped using the key <STOP>. At each start of a
measurement the max, min and average values of all meas.points are cleared,
if the device has been correspondingly configured (standard setting, see 10.8).
Starting a cyclic meas. point scan:
<
START
>
For control purposes the following symbols will
continuously
,
i.e. for the whole meas.period, be indicated in the
status line
:
The start arrow lights up
´
!
´
Lightening up in case of a data output via interface
´
COM
´
Indicated when measured values are being stored (see 8.2):
´
REC
´
Stopping a cyclic meas. point scan:
<
STOP
>
´
"
´
6.2.3 Print Cycle, Timer, Output Format
The function ´Print Timer´ in the standard menu indicates the print cycle, as log
as a measurement has not been started. After starting a measurement the
timer counts down to the next cycle. If the function has been selected (see 5.4)
the print cycle can be programmed (see 5.5) or the key <FORM> can be used
as the quickest way to set the required output format (see 7.2).
Function ´Print Timer´, ´Format List´, ´Memory On´:
PrintTimer:
S
00:02:00
Change format:
<
FORM
>
Format columns side by side ´
n
´:
PrintTimer: nS
00:02:00
Change format:
<
FORM
>
Format table ´
t
´:
PrintTimer: tS
00:02:00
6.2.4 Displaying Measured Values as a Line Chart
When using the menu ´Line Chart´ the meas.
value of the selected channel is indicated as
a line chart with 100x200 dots as soon as a
measurement is started. The curve
continuously moves from the right to the left,
the time resolution is determined by the
cycle
, each scan involves one point (dot).
Therefore, time data for the whole t axis is
given as (days) hours:minutes in the bottom
right corner. In the upper right corner the
time of day is indicated. In this mode, the
curve is also updated during an active
measurement, if the user leaves the
menu (in this case, do not change themeas.point!). Limit values, if activated,
are entered as dotted lines. In addition, another fast display mode is available
24
ALMEMO
®
2590-9
Displaying a Measuring Point
C
!
REC COM
|> >|
R01
"
M
▲
SCALE STOP TIME
20%H
80%H Humidity
16.33
00:10
M00
