Agilent Technologies N9360A, Руководство по программированию

Страница: 48 / 180

5-2 N9360A Multi UE Tester W-CDMA Programming Manual
5
Programming Command Reference
This chapter describes all commands of syntaxes, parameters, and
response.
IEEE Common Commands
The following IEEE common commands are used to set and
monitor the status registers, and to reset the Tester.
IEEE Common Commands Reference
Identification Query
*IDN?
This query command returns the identification information
about the manufacturer name, model number, serial number
and the revision number of the firmware.
Reset
*RST
This command executes the self-test routine and resets the
Tester to the initial state.
Operation Complete
*OPC
*OPC?
This command sets or queries the OPC bit (bit0) of the Standard
Event Status Register (SESR). The query command returns 1.
Clear Status
*CLS
This command initializes the Status Byte Register (STBR) and
the Standard Event Status Register (SESR).
NOTE
The
*RST
command does not affect the settings of the serial, GP-IB and
Ethernet interface configuration.