Agilent Technologies N9360A, Руководство по программированию

Страница: 89 / 180

Programming Command Reference
5
N9360A Multi UE Tester W-CDMA Programming Manual 5-43
bit 8(256): Frequency Error
bit 9(512): EVM
bit 10(1024):Sensitivity/BER
bit 11(2048): Abort
Each bit is set to
0
if the test is pass or skipped, or each bit is set
to
1
if the test is fail.
If there are no test results, all bits are set to
1
, the value
4095
is
returned.
The value in the parentheses is decimal value for each bit. Refer
to
Setting and Querying the Registers on page 14 .
Command Reference for RF Test Result
The following query commands are used to return a set of the
RF test result.
Open Loop TX Power Measurement
TESTs:AUTO:RESults:OPENpower1?
This query command returns the measurement result values,
<int 1>
,
<int 2>
and
<real 3>
, for RFCH 1.
•
<int 1>
(1 digit) is
0
if measurement result is within the
measurement range, or
1
if measurement result is out of
range or the Open Loop TX Power is not measured.
•
<int 2>
(1 digit) is the test result for the pass (0) or fail (1).
•
<real 3>
(up to 5 letters) is the measured data ranging
from
-99.9
to
+99.9
in dBm. If measurement result is out of
range or the Open Loop TX Power is not measured, the value
-99.9
is returned.
The Open Loop TX Power measurement can be executed only on
RFCH1.
Inner Loop Power Measurement (Down MIN)
TESTs:AUTO:RESults:INNErpower1:DownMIN?
TESTs:AUTO:RESults:INNErpower2:DownMIN?
TESTs:AUTO:RESults:INNErpower3:DownMIN?