Agilent Technologies N9360A, Руководство по программированию

Страница: 22 / 180

3-2 N9360A Multi UE Tester W-CDMA Programming Manual
3
Preparing for Use
Equipment for Automated Test System
Ethernet
The following equipments are required to construct an
automated test system using the Ethernet:
• The Agilent N9360A Multi UE Tester (called the Tester
hereafter).
• A system controller with the Ethernet interface.
• A 10Base-T/100Base-TX UTP cross-over cable to connect the
controller and the Tester. Or, two 10Base-T/100Base-TX UTP
straight cables to connect the HUB, the controller and the
Tester.
• An RF cable to connect the RF signals from or to the mobile
phone under test, the Antenna Coupler (Agilent CAU-17) to
connect RF signals from or to the mobile phone to couple RF
signals from or to the mobile phone.
• Printer and an appropriate cable (if required).
A typical setup for an automated test system using the Ethernet
as shown in
Figure 3-1 below:
GP-IB(Option)
The following equipments are required to construct an
automated test system using the GP-IB:
• The Agilent N9360A Multi UE Tester.
• A system controller with the GP-IB interface.
Figure 3-1 Typical Setup for Automated Test System (Ethernet Interface)