Agilent Technologies N9360A, Руководство по программированию

Страница: 30 / 180

4-4 N9360A Multi UE Tester W-CDMA Programming Manual
4
Programming Command Guidelines
• ; (a semicolon) separates commands written in one line.
Although those commands have some common portions,
each command must be written from beginning as the
following example.
CONF:COND:AMPL -70
;
CONF:COND:SENS:FARM 100
• ? (question mark) following a command indicates that the
command is a query. Most of the commands accept the query
command. To make the query command, a question mark is
following to the command. The returned information,
<value>, varies in format according to the type of the
command.
• << (continue) indicates the line does not end and continue to
the next line.
For example,
ABC <<
DEF
Is same as follows
ABC DEF
In addition, all commands, parameters and mark to use in
the programming are the ASCII code characters.
Overview of the Ethernet Interface
Settings for the Ethernet Interface
Refer to the documentation on your controller, programming
language, and LAN card to configure the Ethernet interface.
The Ethernet configuration is not programmable but manually
set. The preset settings and other choices are as follows:
Table 4-1 Ethernet Configuration
Item Preset Allowable Range
IP Addr: 192.168.0.1 0.0.0.0 to 255.255.255.255
Mask: 255.255.255.0 0.0.0.0 to 255.255.255.255
Gateway: NONE NONE, ACT
Addr: 0.0.0.0 0.0.0.0 to 255.255.255.255
Terminator: CR+LF CR+LF, CR, LF