Agilent Technologies InfiniiVision 2000 X-Series, Руководство программиста, Страница: 617 / 930

:TRIGger Commands
29
Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide 617
:TRIGger:PATTern
(see page 790 )
Command Syntax
:TRIGger:PATTern <pattern>
<pattern> ::= <string>[,<edge_source>,<edge>]
<string> ::= "nn...n" where n ::= {0 | 1 | X | R | F} when
<base> = ASCii
<string> ::= "0xnn...n" where n ::= {0,..,9 | A,..,F | X | $} when
<base> = HEX
<edge_source> ::= {CHANnel<n> | NONE} for DSO models
<edge_source> ::= {CHANnel<n> | DIGital<d>
| NONE} for MSO models
<n> ::= 1 to (# of analog channels) in NR1 format
<d> ::= 0 to (# digital channels - 1) in NR1 format
<edge> ::= {POSitive | NEGative}
The :TRIGger:PATTern command specifies the channel values to be used in
the pattern trigger.
In the <string> parameter, each bit corresponds to a channel as described
in the following table:
The format of the <string> parameter depends on the
:TRIGger:PATTern:FORMat command setting:
• When the format is ASCii, the string looks just like the string you see
on the oscilloscope's front panel, made up of 0, 1, X (don't care), R
(rising edge), and F (falling edge) characters.
• When the format is HEX, the string begins with "0x" and contains hex
digit characters or X (don't care for all four bits in the nibble).
With the hex format string, you can use the <edge_source> and <edge>
parameters to specify an edge on one of the channels.
Oscilloscope Models Value and Mask Bit Assignments
4 8 digital channels (mixed-signal) Bits 0 through 7 - digital channels 0 through 7.
Bits 8 through 11 - analog channels 4 through
1.
2 8 digital channels (mixed-signal) Bits 0 through 7 - digital channels 0 through 7.
Bits 8 and 9 - analog channels 2 and 1.
4 analog channels only Bits 0 through 3 - analog channels 4 through 1.
2 analog channels only Bits 0 and 1 - analog channels 2 and 1.