©
Agilent Technologies 1989–2002
Agilent 3070 / 79000 Site Preparation
9-7
Chapter 9: Site Preparation – Receiving and Moving Instructions: Uncrating The System
Using the 5-millimeter hex wrench, remove all the
bolts that fasten the brackets to the testhead. Remove
the brackets from the pallet with the 9/16-inch
open-end wrench or a socket wrench.
10
If you have a 307X system, push the testhead away
from the support bay to provide better access to the
support bay’s shipping brackets. Remove the bolts
connecting the support bay to the brackets with the
6-millimeter hex wrench. Remove the remaining
bolts from the support bay brackets with the
9/16-inch open-end wrench or a socket wrench.
11
With the 9/16-inch open-end wrench or a socket
wrench, remove the four seven-inch bolts that
stabilize the deck of the pallet. This prevents the
casters from catching on them when you roll the
system off of the pallet.
12
Before rolling the system off of the pallet:
■
Clear all people, tools, and equipment from the
area that the system will roll into.
■
Make sure the leveling feet for both the testhead
and support bay, if included, are up. Otherwise,
the feet may drag against the pallet and bend.
■
For a 307X system, replace the foam that was
placed between the testhead and the support bay
to prevent scratching and denting of the cabinets.
WARNING
✸
Use at least two people to roll the tester off of the
pallet. For a 307X system, one person should
steady the two bays as the second pushes them
down the ramp.
Be careful not to push against the plastic skirt that
surrounds the modules of the testhead.
13
Discard all the packing material and the pallet, unless
you anticipate shipping the system to another facility.
