Agilent Technologies 1260 Infinity G1315C, Руководство пользователя

Страница: 277 / 314

Agilent 1260 Infinity DAD and MWD User Manual 277
LAN Configuration
13
Automatic Configuration with BootP
Two Methods to Determine the MAC Address
Enabling logging to discover the MAC address using BootP
If you want to see the MAC address, select the
Do you want to log BootP requests?
check box.
1 Open BootP Settings from Start > All Programs > Agilent BootP Service >
EditBootPSettings .
2
In
BootP Settings...
check
Do you want to log BootP requests?
to enable logging.
Figure 94 Enable BootP logging
The log file is located in
C:\Documents and Settings\All Users\Application Data\Agilent\BootP\LogFile
It contains a MAC address entry for each device that requests configuration
information from BootP.
3
Click
OK
to save the values or
Cancel
to discard them. The editing ends.
4
After each modification of the BootP settings (i.e.
EditBootPSettings
) a stop
or start of the BootP service is required for the BootP service to accept
changes. See
“Stopping the Agilent BootP Service” on page 281 or
“Restarting the Agilent BootP Service” on page 282.
5
Uncheck the
Do you want to log BootP requests?
box after configuring
instruments; otherwise, the log file will quickly fill up disk space.
Determining the MAC address directly from the LAN Interface card label
1 Turn off the instrument.
2 Read the MAC address from the label and record it.
The MAC address is printed on a label on the rear of the module. It is the
number below the barcode and after the colon (:) and usually begins with
the letters AD, see
Figure 84 on page 262 and Figure 85 on page 262.
3 Turn on the instrument.