Aeronaut 3033/00, Руководство по сборке

Страница: 4 / 44

With a sanding block sand contact surface for
rear keel parts 6 smooth.
For rear keel installation drill two 1.5 mm holes for tapping
screws 9 into hull.
Accurately position the rear keel on the contact surface and
secure with tape. Mark position of holes and drill through hull
into keel.
Note: At a later stage the rear keel will be glued to the hull
with Stabilit Express (or similar glue that is suitable for gluing
polystyrene with other materials) and at the same time
secured with tapping screws 9 and washers 10.
Position rear keel parts on
contact surface of hull and
check distance for rudder
installation as indicated.
The distance should measure
70 mm.
5
7
6
70 mm