![Aeronaut 3033/00 Скачать руководство пользователя страница 12](http://html1.mh-extra.com/html/aeronaut/3033-00/3033-00_assembly-instructions-manual_2862741012.webp)
Lightly sand contact surfaces of deck and hull. Position deck as accurately as
possible on hull, glue in place and secure with clamps until glue has dried.
.
Note:
Use glue that reliably bonds styrene to wood, for example Ruderer L530 or
Stabilit Express.
When glue has cured, treat deck and rudder linkage hatch cover 36.2 with a
suitable primer.
Cut out bulwark 2 from mould leaving a 4 mm wide rim around the
circumference which serves as a contact surface for gluing.
Trial-fit bulwark onto hull and correct, if necessary. Fix bulwark on hull
with clamps and with a soft pencil mark position of inner edge of
bulwark on deck to define contact surface for gluing. Mask off the
deck´s contact surface with tape 1 mm inside the pencil line. Then paint
the deck.
Note:
Steam tugs of that era generally have steel decks, which can be
painted in your favourite colour.
Clean bulwark throughly with warm water and a mild detergent, then
lightly sand with fine wet sanding paper. Paint inside of bulwark. When
paint has dried, carefully remove any paint from contact surface of
bulwark.
Glue bulwark onto deck and hold in place with clamps until glue has set
completely. Inspect outside of gluing joint and use filler and sandpaper
to correct any blemishes.
Note:
Use glue that reliably bonds styrene to wood, for example
Ruderer L530 or Stabilit Express.
28
29
30
2
Содержание 3033/00
Страница 1: ...aero naut S dersand Order No 3033 00...