Aeronaut 3033/00, Руководство по сборке

Страница: 2 / 44

Thank you for buying an aero-naut kit!
Südersand
is the model of a small steam tug in 1:20 scale, which was in use in
the 20ies and 30ies of the last century. This kit contains precisely laser-cut parts and
a sheet of photo-etched brass parts for the fine details which give the model its realistic
appearance.
Before you begin, please read the instruction manual carefully and completely for a better
understanding of the design of this model. Pre-treatment of parts and assemblies and the
application of paint should be planned ahead of the building process. Depending on your
favourite colour scheme it may be necessary to change the building sequence given in the
instruction manual and to paint individual assemblies before installation.
Construction should be according to the step-by-step instructions provided in the manual. Use a
sharp modeller´s knife to cut the tabs of the laser-cut parts. Use fine sandpaper to remove any
residue of the laser-cutting process from parts, to sand off tabs, create good contact surfaces for
gluing and enhance the overall appearance of your model.
Before you glue, always check that parts fit perfectly and correct, if necessary. Give glue sufficient
time to dry or cure before you proceed to the next building step.
You can apply your favourite colour scheme to your model. Make sure to clean the polystyrene
hull thoroughly and to use a primer suitable for your paint job. Treat deck and superstructure with
sanding sealer and filler before you apply paint to achieve a smooth surface.
Recommended glues
Material
Glue Order.-No.
wood/wood Ponal Express 7638/10
UHU hart 7631/02
wood/metal, metal/metal UHU plus endfest 7633/02
UHU plus schnellfest 7633/04
ABS/metal, ABS/wood Stabilit Express 7646/01
Recommended primer
Material
Item Order.-No.
mahogani, plywood Sanding sealer 7666/02
Südersand
We recommend to use our aero-pick
modeller´s pins.
Order.-No. 7855/02
Recommended accessories
Spring coupling
for various shaft diameters:
Shaft diameters Order.-No.
3/4 mm 7034/16
3,17/4 mm 7034/21
4/4 mm 7034/22
Servo
AN-20-MGBBA 7003/75
Technical data
Scale: 1:20
Length: ca. 737 mm
Beam: ca. 220 mm
Height: ca. 370 mm
Weight: ca. 3.300 g
Recommended drive system (brushed motor)
Item Description Order-No.
Motor Race 620 Navy 7000/47
ESC Multi 25 7019/71
Propeller 3-blade, 50 mm 7170/77
Coupling 3,17/4 mm 7034/21
Battery 2S-LiPo
Recommended drive system (brushless motor)
Item Description Order-No.
Motor actro-n 28-4-880 7003/04
ESC actro-marine 30 7003/42
Propeller 3-blade, 50 mm 7170/77
Coupling 4/4 mm 7034/22
Battery 2S-LiPo