Aeris CompuMask, Руководство по эксплуатации

Страница: 134 / 149

134
Transmitter Battery Installation
 Lightly lubricate a new (recommended) Battery Cover O-ring
with silicone grease and install it on the Battery Cover,
stretching it slightly to work it down over the slotted end of
the Cover into the Groove above the Threads (Fig. 119).
DO NOT roll the O-ring over the Threads.
 The O-ring must be a genuine AERIS part. Use of any other
O-ring may result in an improper seal and leakage.
 Place a new 3 volt, CR2, Lithium Battery (Duracell
®
model DL-
CR2 or equivalent) positive ( + ) side down into the Battery
Compartment with the negative end facing up/out.
 Ensure that the Battery is properly oriented (Fig. 120) and
the Cover O-ring is evenly seated around the Battery Cover.
 Carefully place the Battery Cover with Spring into the Hous-
ing and turn clockwise slowly by hand to ensure proper
threading.
 Apply a coin and tighten clockwise until secure. The outer
surface of the Battery Cover should be flush with the outer
surface of the Housing (Fig. 121).
Fig. 121 - BATTERY COVER
INSTALLED
Fig. 119 - TRANSMITTER
O-RING INSTALLATION
Fig. 120 - BATTERY
ORIENTATION
Battery
(+) ( - )