Aeris CompuMask, Руководство по эксплуатации

Страница: 132 / 149

132
 If it is necessary to clean the Battery Compartment, flush it
and all components with a solution of 50% white vinegar
and 50% fresh water. Rinse with fresh water, and allow to
dry overnight, or blow dry with a hair dryer set at no heat.
Mask Battery Installation
 Lightly lubricate a new Battery Cover O-ring with silicone
grease and place it on the beveled outer edge of the Battery
Compartment (Fig. 116). Ensure that it is evenly seated.
 The O-ring must be a genuine AERIS part. Use of any other
O-ring may result in an improper seal and leakage.
 Place a new 3 volt, CR2, Lithium Battery (Duracell
®
model DL-
CR2 or equivalent) negative end first into the Battery Com-
partment with the negative end toward the Spring. Ensure
that the Battery is properly oriented.
 Carefully place one side of the Battery Cover into position so
that it is seated on top of the Cover O-ring (Fig. 117) and
while holding it in place, press the other side down into
place.
 While holding the Cover firmly in place, secure it with the 2
Screws by alternately turning each of them clockwise 1 turn
at a time.
 The outer surface of the Battery Cover should be flush with
the outer surface of the Housing (Mask Frame).
Fig. 117 - BATTERY COVER
INSTALLATION
Fig. 116 - BATTERY
O-RING AND BATTERY
INSTALLED