ADEMCO VISTA-120, Инструкция по установке и настройке

Страница: 84 / 176

– 76 –
*43
SUPPRESS WIRELESS SIREN ACTIVATION FOR
[0]
FIRE ALARMS
1 = suppress wireless siren activation on fire alarms (sounds for
burg. Alarms)
0 = wireless siren sounds for fire alarms (and burglary alarms)
*44
RING DETECTION COUNT
[0] |
01-14 = ring counts of 1-14
00 = disable ring detection
15 = select answering machine defeat mode, which allows the system to
receive calls even when a telephone answering machine is
connected to the same phone line. In the answering machine mode,
the caller should let the phone ring once, then hang up, and call
again within 30 seconds. The system, upon hearing one ring
followed by nothing, will not answer the first call, but will ready
itself to pick up on the first ring of the next incoming call that is
received within 30 seconds (the downloader calling again).
Only applicable if using a 4285 telephone module and/or if remote
initiated downloading will be used.
*45
PRIMARY FORMAT
[0]
0 = Low Speed 2 = Ademco Expanded High Speed
1 = Contact ID 3 = Ademco Express
Selects the reporting format for use on the primary telephone number.
*46
LOW SPEED FORMAT (PRIMARY)
[0]
0 = Ademco Low Speed
1 = Sescoa/Radionics
*47
SECONDARY FORMAT
[0]
0 = Low Speed 2 = Ademco Expanded High Speed
1 = Contact ID 3 = Ademco Express
Selects the reporting format for the secondary telephone number.
*48
LOW SPEED FORMAT (SECONDARY)
[0]
0 = Ademco Low Speed
1 = Sescoa/Radionics
*49
CHECKSUM VERIFICATION
[0]
1 = either or both primary/secondary formats send a verification digit to
validate the message at the receiver without having to send two
message rounds. Selection is valid for 3+1, 4+1, and 4+2 reports.
0 = no checksum verification
*50
SESCOA/RADIONICS SELECT
[0]
0 = Radionics format with hexadecimal 0-9, B-F reporting
1 = SESCOA format with only numeric reporting (0-9).
Selection applies to both primary and secondary phone numbers.
*51
DUAL REPORTING
[0]
1 = all reports sent to both primary and secondary phone numbers. If
used with Split Reporting option 1 (1*34), alarms go to both primary
& secondary numbers, while all other reports go to secondary only. If
used with Split Reporting option 2, alarms go to both lines,
open/close and test messages go to secondary only, while all other
reports go to primary.
0 = no dual reporting
*52
STANDARD/EXPANDED REPORT PRIMARY
[0]
0 = standard reporting for the primary phone number
1 = expanded reporting for the primary phone number
Note: Expanded overrides 4+2 format.
*53
STANDARD/EXPANDED REPORT SECONDARY
[0]
0 = standard reporting for the secondary phone number
1 = expanded reporting for the secondary phone number
Note: Expanded overrides 4+2 format.