Acme Packet Net-Net 6300, Руководство по установке оборудования

Страница: 59 / 116

SYSTEM INSTALLATION
Version 1.0 Acme Packet, Inc. Technical Publications 55
2. Insert the RJ45 connector on the end of the alarm port cable into the alarm port
labeled
Alarm . The release tab on the RJ45 jack clicks into place when you insert
it properly.
3. Lead the alarm cable neatly away from the rear panel toward any alarm
monitoring equipment.
The following figure shows a Net-Net 6300 with an alarm cable properly
connected.
Management
Network Ports
Standard shielded CAT5e or CAT6 (or higher) Ethernet cables with RJ45 jacks are
used for connecting the Net-Net 6300 management Ethernet ports to your network.
These ports support 10/100/1000 Mbps speeds.
Note: Keep Ethernet cables separated from power cables by at least
60mm where possible and never run them in the same channel of a
trunking system without segregation.
Cabling Procedure To connect Ethernet cables to the rear panel Ethernet ports:
1. Locate the Ethernet cables you plan to connect to the Net-Net 6300.
2. Insert the RJ45 connector on the end of the Ethernet cable into one of the NIU
management Ethernet ports. These ports are labeled
Mgmt0 , Mgmt1 , and