Acme Packet Net-Net 6300, Руководство по установке оборудования

Страница: 90 / 116

88 Net-Net 6300 Hardware Installation Guide Version 1.0
MAINTENANCE INTRODUCTION
SFP+ Removal and Replacement
Your troubleshooting and diagnostics might reveal that the SFP+ component of a
NIU card needs to be replaced. The SFP+ serves two functions:
• Converts electrical signals into optical signals used to communicate with other
optical networking equipment.
• Serves as the receptacle for the LC duplex fiber optic connectors.
SFP+ are hot swappable and may be replaced while the Net-Net 6300 is powered
on. Leave the NIU in the Net-Net 6300 as you extract the SFP+.
To obtain a SFP+, contact your Acme Packet sales representative directly or by email
at tac@acmepacket.com.
SFP+ Media Signaling Interfaces
This section describes the media signaling interfaces, small form factor pl.
The signaling and media interface, provide network connectivity for the signaling
and media traffic. Each interface can connect to a network at 10 gigabit ethernet
speeds.
SFP+ Information
Only transceivers qualified by acme packet can be used in the Net-Net 6300. Mixed
transceiver types are unsupported. Both transceiver locations must be populated
with the same SFP+ type based on compliance testing.
SFP+, are inserted into the NIU card.
•
850nm LASER PROD Check the label on the back of the SFP+ for this
information to make sure you have the right mode transceiver. Black bale clasp
latch-Multi Mode.
• 1310nm LASER PROD Check the label on the back of the SFP+ for this
information to make sure you have the right mode transceiver. Blue bale clasp
latch-Single Mode.
SFP+ Identification
The following image shows the 10 gigabit SFP+ transceiver used in the Net-Net 6300
NIU cards. The arrow indicates a Black bale clasp latch- Multi Mode.