Acme Packet Net-Net 6300, Руководство по установке оборудования

Страница: 68 / 116

66 Net-Net 6300 Hardware Installation Guide Version 1.0
MAINTENANCE INTRODUCTION
Shutting Down the
Net-Net 6300
To shut down the Net-Net 6300 hardware:
1. Exit the ACLI and close your console or network connection.
2. Unplug the AC power cords from the power supplies on the rear panel of the
Net-Net 6300.
3. Confirm that the graphic display is dark and all fans are off.
Rebooting, Resetting, and Power Cycling
Reboot
Rebooting the Net-Net 6300 shuts down the system in an orderly fashion and then
starts it up again. The operating system gracefully shuts down as processes are
terminated and the filesystem is stopped. While the system and its processes are
stopped, all call processing is immediately halted. You may therefore wish to
perform tasks that call for a reboot during off-peak maintenance hours.
Rebooting the Net-Net 6300 is required every time you upgrade with a new version
of the Net-Net 6300 software.
Before rebooting the Net-Net 6300, save your configurations. The save-config
command is used to save the configuration in the example below.
For a full explanation and all options for the reboot command used in the example
below, refer to the ACLI Reference Guide .
To reboot the Net-Net 6300:
1. Save any configuration changes you have made in the ACLI by typing save-
config <Enter> in Superuser mode.
ACMEPACKET# save-config
Save-Config received, processing.
waiting 1200 for request to finish
Request to 'SAVE-CONFIG' has Finished,
Save complete
Currently active and saved configurations do not match!
To sync & activate, run 'activate-config' or 'reboot activate'.
ACMEPACKET#
2. Execute the reboot command at the Superuser prompt by typing reboot and
then pressing <Enter>.
ACMEPACKET# reboot
-----------------------------------------
WARNING: you are about to reboot this SD!
-----------------------------------------