Acme Packet Net-Net 6300, Руководство по установке оборудования

Страница: 19 / 116

COMPONENT OVERVIEW
Version 1.0 Acme Packet, Inc. Technical Publications 17
alarm control signal interface that can be used in a CO location to indicate when
internal alarms are generated. The Net-Net 6300 uses alarm levels that correspond
to three levels of service-disrupting incidents. When any of the three alarm levels is
generated, the corresponding circuit for that level on the alarm port is closed.
Alarm Levels The following table lists the three alarm levels:
The alarm port uses a standard RJ45 connector. Refer to the image of the Net-Net
6300 rear panel in the "
Rear Panel " section to see the location of the alarm port.
Alarm Port Pin-out The following table lists the pin assignments for the alarm port using an RJ45
connector.
Network
Management Ports
The Net-Net 6300 has three 10/100/1000 Base-T Ethernet ports located in the rear
left side of the chassis, labeled Mgmt0 Mgmt1 Mgmt2. These ports are used for EMS
Alarm Type Description
Minor Functionality has been impaired to a small
degree (e.g., a single fan has failed).
Major Pending failures or unexpected events
(e.g., a loss of signal).
Critical Catastrophic condition has occurred (e.g.,
the system is overheating).
Pin Number Signal Name/Description
1 Minor Alarm (Pin 1)
2 Minor Alarm (Pin 2)
3 Major Alarm (Pin 1)
4 Major Alarm (Pin 2)
5 Critical Alarm (Pin 1)
6 Critical Alarm (Pin 2)
7 Ground
8 Ground