40
Send a total of three times, each time one minute interval.
19. ACC detect charge function
1) For Charge
Description: ACE-TL210 check the state of ACC of the power through the ACC Cable,so the ACC
ON when the car is moving, and the power of the car will recharge to the unit. and the ACC Off
when the car is parking, and the power of the car will not recharge to the unit.
2)The On/Off Command for ACC State
Open Command of ACC State : 091+ Password
Eg :0910000
Close Command of
ACC State : 090+ Password
Eg:0900000
Note: when ACE-TL210 receive the 091 command, and confirm the password is correct.ACE-TL210
will send a message to the sender what the content is "ACC STATE PROMPT:ON". when ACC is
ON/OFF
，
the ACE-TL210 will send the current position to the pre-saved numbers whether the GPS
Data is avaible or valid, and the state will display “AUTO START/AUTO STOP”be the ACC State.
when ACE-TL210 receive the 090 command, and confirm the password is correct. ACE-TL210
will send a message to the sender what the content is "ACC STATE PROMPT:OFF". when ACC is
ON/OFF
，
the ACE-TL210 will not send any message whatever the unit is GPRS Or SMS Mode .
Attention : the default is ON, and once the configuration is ok whatever the unit is ON/OFF, the unit
will not change until receve the next command or reset command
20. ACC Checking and Alarm for Moving
Alarm Command for Moving :008+PRzzz.z
Close Alarm Command for Moving : 009+Password
Note: when ACE-TL210 receive 008 command, and confirm the password is correct,put Rzzz.z for
the radius of area. the zone of zzz.z
is
【
0.1
～
999.9
】
, the unit is KM. after configuration is ok,
ACE-TL210 will send "SET MOVE RADIUS OK"to the sender.
After configuration of the alarm for moving is complete, if ACE-TL210 checking the ACC State is
changed which from ACC ON to ACC OFF, after three minutes, the ACE-TL210 will take the
current position for the coordiration point, the unit will open the defence(use the zzz.z) whether the
GPS Data is Available or Valid .
