36
Update gps data whether is available. If ok, take the lat/log to the coordination, and the R for
The Radius, and also pen the Geofence at the same time. If the configuration is ok. The unit
Will send "set geo fence ok " to the sender. If the update GPS Data void, the unit will give
up and then red the next one, if the unit can't receive the data above 50sec, the unit will send
A message to the sender which is "ERROR GPS DATA, TRY AGAIN LATER"
1.1>. Open the electronic fence:
211 + user password
when the ACE-TL210 received confirmation of the order after the user password open the e-
fence to the right side to return the confirmation messages sent: GEO-FENCE ON.
1.2> turn off the electronic fence:
210 + user password
when the ACE-TL210 received confirmation of the order the correct user password and close
the electronic fence to return to the sender is recognized short message: GEO-FENCE OFF.
Note: 1, the fence can not exceed the radius of the domain, the fractional part of the right of zero
must enter zeros. For example: R = 1, must be entered as 1.0.
2, if the calling state is off, it will not make calls, only send messages to the user.
3, the degree and is divided into 60 hex conversion, that 1d = 60m.
2) set the rectangular range of the electronic fence
Instruction format: 006 + user pa GX, IO / I / O, E / W longitude limit + N / S latitude limit,
E / W longitude limit + N / S latitude limit
for example: 0060000G1 , IO, E114.10004N22.55705, E115.10006N23.55706
Description: GX, said the electronic fence X, X range
【
1,16
】
. IO fencing in and out of all alarms; I
selected as a finalist alarm; O as a fence alarm. Latitude and longitude values in degrees, decimal
point to be retained after five, followed by zero can not be omitted. IO: fences are out of the alarm; I:
Finalist bar alarm; O: a fence alarm;
When the device receives the instruction to confirm the user password correctly, the sender returns
confirmation messages: SET SQUARE GEO-FENCE GX (IO / I / O) OK.
Note: (1) is set up, automatically open the fence, then the default fence type I0: out of the fence are
the police.
(2) If the calling state is off, it will not make calls, SMS mode, only send messages to the user.
(3) The setting of this directive, and the switch from power-down effect of changes until you receive
