18
Format2
：
004+ user password E/W
ddd.ddddd
N/S
dd.ddddd
Rzzz.z
eg
：
0040000E114.10004N22.55705R999.9
Explanation: E-- east longitude; W-- west longitude; N-- north latitude; S-- south latitude. In
this example, uses E and N, please according to the actual geographical position choose
corresponding coordinate form to set. In the demonstration, meanings of various parts are as follows:
E
ddd.ddddd
is longitude information with units of degrees, and the
ddd.ddddd
expresses degree
(Accuracy for 5 after the decimal point, the following zero cannot bypass)
N
dd.ddddd
is latitude information with units of degrees, and the
ddd.ddddd
expresses degree
(Accuracy for 5 after the decimal point, the following zero cannot bypass)
Rzzz.z is radius for the domain (
999.9 - 0.1
), unit for KM.
When the tracker receives this instruction, judges to be authorized users and confirms the user
password correctly, it will send the confirmation messages “SET GEO-FENCE OK” to the sender.
Note: 1. Radius of the fence can not exceed the definition of its domain; the value of the
decimal part for zero must input zero fill. For example: R=1, it is important to enter into 1.0.
2. If the calling state is off, it will not call the user telephone number, and only send
messages to the present number.
3. Degree and minute is divided into sexagesimal system converter, that is, 1d = 60m
Format 3 : 005+User Password Rzzz.z
eg: 0050000R0.1
Note : When this unit receive this command and confirm the password is right. And read the
Update gps data whether is available. If ok, take the lat/log to the coordination, and the R for
The Radius, and also pen the Geofence at the same time. If the configuration is ok. The unit
Will send "set geo fence ok " to the sender. If the update GPS Data void, the unit will give
up and then red the next one, if the unit can't receive the data above 50sec, the unit will send
A message to the sender which is "ERROR GPS DATA, TRY AGAIN LATER"GPS restore the
original settings after the state (on / off / adaptive).
1.1>. Open the electronic fence: 211 + user password
when the ACE-TL210 received confirmation of the order after the user password open the e-fence to
the right side to return the confirmation messages sent: GEO-FENCE ON.
