Accu-Turn 1400, Руководство оператора

Страница: 69 / 87

70
ACCU 14 2 0
Installation Instructions
Operator’s Manual
i-1
This appendix describes the installation requirements,
installation procedures and checks.
i. Installation requirements.
Space requirements.
The drawings show the minimum requirements from a
safety viewpoint.
Refer to drawing i-1 for space requirements.
Each drawing has 2 sets of dimensions:
1 from the walls to the center of the holes (on the left
and top of the drawing);
2 from the walls to the side of the cabinet (on the right
and bottom of the drawing).
Floor requirements.
The floor should be:
- horizontal; within 2°
- level; within 2 mm
- able to bear the weight of the balancer as stated in
Chapter 2 of the Operator’s Manual.
The floor on which the balancer will be installed should
not relay vibrations from other devices or from outside
the building. External vibrations may affect the accu-
racy of the unit.
Note: The balancer should be positioned on the
floor directly. Do not use rings to fill gaps.
If the above conditions are met, you do not need to
secure the balancer to the floor.
Power supply requirements.
Refer to Chapter 2 of the Operator’s Manual for mains
power requirements.
WARNING: ENSURE THAT AN APPROVED WALL
MAINS OUTLET IS AVAILABLE.
WARNING: NEVER GUIDE POWER SUPPLY
CABLES OVER THE FLOOR, UNLESS PRO-
TECTED BY AN APPROVED COVER.