Accu-Turn 1400, Руководство оператора

Страница: 17 / 87

18
ACCU 14 2 0
Layout
Operator’s Manual
4.1-1
4.1 The display.
Refer to Figure 4.1-1.
Note: Positions related to the internal (left) plane
of the wheel are labeled with a number
followed by “a”, while for external (right)
plane positions the number is followed by
“b” (e.g.: 1a, 1b).
1. Weight Application Position (WAP) indica-
tor.
As the corrective weight position on the wheel
reaches 12:00, all weight application position (WAP)
indicator lights will illuminate confirming that you
have located the position for weight application. All
weights will be applied at 12:00 with all WAP lights
illuminated.
2. Display.
Depending on the stage of the program the display
gives the operator information about rim sizes, bal-
ancing weights, error codes, etc.
3,7
Weight position indicator.
Fit a clip-on weight at the rim position indicated
when the relative WAP indicator lights up.
4,5,6
Weight position indicator.
Fit a stick-on weight at the rim position indicated
when the relative WAP indicator lights up.
8
Motorcycle Dynamic and Static Indicator.
The indicator lights up when you activate the mo-
torcycle wheel balancing program or the single
weight (static mode).
9
PAX wheel Indicator.
The indicator lights up when you activate the PAX
SYSTEM wheel balancing mode.
4.1.1 Audible System signals.
Possible beeps:
High:
the unit returns a short high beep at the start of the
balancing cycle. or after activating a key. Refer to
Chapter 4.2.
Low:
the unit returns a low beep if an error is detected,
usually together with a system message indicating
the nature of the error.
For all other audible beeps, refer to Chapter 7, as these
indicate errors.