Accu-Turn 1400, Руководство оператора

Страница: 41 / 87

42
ACCU 14 2 0
Operations
Operator’s Manual
5.3.3 Spinning the wheel.
The wheel type and dimensions must have been en-
tered.
•
Pull the tilting hold frame down to its horizontal
position.The motor will start automatically, the wheel
will spin.
The measurement is completed as soon as the direc-
tion indicators light up. The unit will beep. The brake
will be applied automatically.
The weight(s) to be applied will be shown on the dis-
play. For maximum precision, select Fine.
•
Raise the tilting frame to its vertical position.
“S - 2” will appear on the right display. Rotate in the
opposite direction until you find the radial where the
above mentioned index appears.
Note:
The field where “S – 2” appears on the dis-
play is wider than radial width, therefore make
sure the radial is positioned exactly at 12
o’clock before pressing “F” again.
•
Press button “F”.
An unbalance less than the initial one appears on the
display on the right hand side.
•
Rotate and block the wheel in the right plane WAP posi-
tion.
•
Arrange the indicated weight in the arm applicator.
•
Move the detector arm to point 0 (zero) of counterweight
application, indicated by the display.
•
Rotate the arm towards the rim and apply the adhesive
weight.
•
Rotate and block the wheel in the second WAP position
of the same plane.
•
Repeat the fastening operation as indicated above for
the first weight.
•
When finished, perform a check spin.