Accu-Turn 1400, Руководство оператора

Страница: 31 / 87

32
ACCU 14 2 0
Operations
Operator’s Manual
- wait 20 seconds
- switch the balancer on again.
•
Carefully repeat the commands with the manual at
hand.
•
Call Accu Service immediately if the unit does not
operate correctly:
WARNING: DO NOT ATTEMPT TO USE THE BAL-
ANCER IF START-UP SELF TEST IS NOT SUC-
CESSFUL.
5.2.3 Shutting down.
Always shut down properly at the end of a work shift:
•
Remove the wheel from the balancer.
•
Remove the cones and quick-release wing nut from
the stub shaft. Check the surfaces (internal and exter-
nal) of the cones for damage. The cone is very impor-
tant for a good balance quality.
•
Check the thread of the quick-release wing nut.
•
Clean all threads and surfaces with a dry, soft cloth.
•
Store the cones and the quick-release wing nut in
the correct place.
•
Unplug the power cord from the power outlet.
•
Check the power cord for damage or wear.
•
Clean up the weight storage areas.
•
Clean the display and control panel with a soft, dry
cloth.
•
Remove old wheel weights and other material from
under the balancer. The balancer must rest stably on
its three feet only.
5.2.4 Settings.
When you switch on the unit, a balancing weight posi-
tioning mode is automatically shown. If the unit comes
up with a balancing weight application mode different
to the one you want, refer to Chapter 5.3.2.
At power up, the units of measurement are ounces for
weight imbalance and inches for wheel parameters.