58
Chapter 4 Learning the basics
Controlling submasters
There are four ways to manually bring a submaster up on stage. You
can use a submaster slider, a submaster bump button, a submaster
bump button in [Solo] mode, or you can load the submaster to one of
the cross faders and use the cross fader to control the submaster.
Using submaster sliders
To use the submaster slider, set the slider at the desired output level.
As you move it from
0
to
10
, the output level increases from zero to
100 percent. You can set the intensity level of the recorded channel
levels at any point between
0
and
10
. For example, if you recorded
channels set at
10
in a submaster, and then set the submaster slider
at
5
(50 percent), the channels would output at 50 percent.
Using submaster bump buttons
The submaster bump button allows you to force a submaster to 100
percent of its recorded level for as long as you press the button.
When you release the bump button, the channels in the submaster
revert to their previous levels.
Using submaster bump buttons with [Solo]
The submaster [Solo] button has the same effect as the submaster
bump button, but it also suppresses the output levels of all other
submasters to zero. It does not affect channels set with channel
sliders, memories or chases.
Using a cross fader
Set the cross fader in which you want to load the submaster to zero.
Press the [Load] button over the cross fader. Press the submaster
bump button of the submaster you want to load. Move the cross
fader toward
10
to bring up the channel levels recorded in the
submaster.
www.carlosmendoza.com.mx
Содержание 300 series
