Chapter 5 Learning advanced techniques
73
Editing memories
Follow these steps to change the output levels of channels in an
existing memory.
1. Press [Mem]. Display reads:
To Record, Select Mem#
LOAD
SAVE
EDIT
2. Press [F3] (Edit), then press the channel bump switch that
corresponds to the memory you want to edit. Display reads:
Editing>3
Chn>9
Lev>45
LAST
NEXT
LEVEL
In this example memory 3 is being edited, the output of channel 9
is being altered and the current output level of channel 9 is 45
percent.
3. Use [F1] (Last) and [F2] (Next) to scroll through the options until
the channel number you want to alter is displayed at
Chn>
.
4. Press [F3] (Level) to change channel output level.
5. Press [F1] (Down) or [F2] (Up) to decrease or increase the output
level displayed in the upper right hand corner of the display.
6. Press [F3] (Set) to set the channel at the new level.
7. Press [Mem] again to record the modified memory.
www.carlosmendoza.com.mx
Содержание 300 series
