Chapter 5 Learning advanced techniques
71
Controlling memories
Memories are controlled with the channel sliders and bump buttons.
To work with memories using the channel controls, press one of the
[Memory] buttons to the right of the scene A and B sliders. You can
use both rows to control memory output, use both rows to control
channel output, or use one row to control memory output and one to
control channel output.
Press [Memory] button again to disable Memory mode.
There are four ways to bring a memory up on stage. You can use a
channel slider, a channel bump button in regular or [Solo] mode, or a
cross fader. To use channel controls to control a memory, press the
[Memory] button next to the row of channel sliders in which the
memory is stored. The [Memory] LED lights.
Using channel sliders
To bring up a memory, move the slider to the desired output level. As
you move it from
0
to
10
, the level of intensity increases from zero to
100 percent. For example, if you record channels at 80 percent in a
memory, then set the channel slider at
5
(50 percent), the channels in
the memory are set at 40 percent.
Using channel bump buttons
Press [Memory] then press the bump button that corresponds to the
memory you want to bring up. The bump button forces the memory
to 100 percent of its recorded level for as long as you press it. When
you release the bump button, the channels in the memory revert to
their previous levels.
Using channel bump buttons with [Solo]
[Solo] has the same effect on individual memories as it does on
channels. It raises the output of the memory to 100 percent of its
recorded level and suppresses all other memories to zero. Only output
of other memories are affected.
Using a cross fader
Set the cross fader in which you want to load the memory to zero.
Press the [Load] button over the cross fader. Press the channel bump
button where the memory you want to load is stored. Move the cross
fader toward
10
to bring up the channel levels recorded in the
memory.
www.carlosmendoza.com.mx
Содержание 300 series
