60
Chapter 4 Learning the basics
Modifying submasters
Follow these steps to change the output levels of channels in an
existing submaster.
1. Press [Subs]. Display reads:
To Record, Select Sub #
LOAD
SAVE
EDIT
2. Press [F3] (Edit), then press the bump button of the submaster
that corresponds to the submaster you want to edit. Display reads:
Editing> 3
Chn>9
Lev>45
LAST
NEXT
LEVEL
Note: In this example submaster 3 is being edited, the output of
channel 9 is being altered and the current output level of channel 9 is
45 percent.
3. Use [F1] (Last) or [F2] (Next) to scroll through the options until the
channel number you want to alter is displayed at
Chn>
.
4. Press [F3] (Level) to change channel output level.
5. Press [F1] (Down) or [F2] (Up) to decrease or increase output
level displayed in the upper right hand corner of the display.
6. Press [F3] (Set) to set the channel at the new level.
7. Press [Subs] again to record the modified submaster.
www.carlosmendoza.com.mx
Содержание 300 series
