18
Chapter 3 Entering softpatch and system settings
Setting default output level
When you use default softpatch, the default output level assigned to
each dimmer is set by the default level assignment.
The factory-set default level is 100 percent. Follow these steps to
change the default output level. Once you have entered the new
default output level, you must reconfigure your softpatch to
incorporate the new default level. Follow the instructions in
Entering
default one-to-one softpatch on page
XX
to enter the new default
softpatch.
1. Press [Setup]. Display reads:
Setup Utility
DISK
CONFIG
2. Press [F3] (Config); display reads:
Select Setup Desired
PATCH
CONSOLE
QUIT
3. Press [F1] (Patch).
4. Use [F1] (Last) and [F2] (Next) to scroll through options until
display reads as below.
4 Default Level
95
LAST
NEXT
CHANGE
www.carlosmendoza.com.mx
Содержание 300 series
