ABB IRB 6700 - 150/3.20, Руководство по эксплуатации продукта

Страница: 66 / 846

Fitting the transport support
Note Action
Do not tighten the screw. Fit the transport support’s lower end to the
robot using the recommended screw joint,
(A) in figure. 1
See attachment point for the specific ro-
bot in the section
Transport position with
a transport support on page 63 .
CAUTION
Do not try to jog the robot to the exact
position (max distance 1mm).
Jog the robot into a position as near above
as possible to the recommended transport
position for the specific robot, as specified
in section
Transport position with a transport
support on page 63 .
2
See attachment point for the specific ro-
bot in the section
Transport position with
a transport support on page 63
Use the brake release for axis 3 to reach the
final resting position on the transport support,
see the section
Manually releasing the brakes
on page 85 .
3
CAUTION
Do not attempt to tighten any attachment
screws without first releasing the brakes.
This can seriously damage the robot.
Tighten all the attachment screws, (A) and
(B), in the figure with the brake release for
axis 3 still activated starting with the lower
attachment screw. 4
Use the brake release for axis 5 and 6 to
reach the final resting position for the tool,
see the section
Manually releasing the brakes
on page 85
5
66 Product manual - IRB 6700
3HAC044266-001 Revision: N
© Copyright 2013 - 2018 ABB. All rights reserved.
2 Installation and commissioning
2.3.2 Securing the robot with a transport support
Continued