A&D RA3100 Omniace, Инструкция по эксплуатации

Страница: 80 / 176

8.Setup Details - 8.1.Recording Setup
80 1WMPD4004444
Setup Unique to Module Types
Tap the module type (RA30-xxx) to display a list of the settings unique to the same type of installed
module. For information on the settings for each module, see "9. Using Optional Modules". An example
of the RA30-101 is indicated below.
Tap RA30-101 to display a list of the settings unique to the RA30-101 (two channel voltage module).
The items in the list are indicated below.
CH: Displays the slot number and channel number, connected with a hyphen.
Coupling: Displays the state of coupling (DC, AC, or GND) that is set. Tap to set coupling.
Meas. range: Displays the measurement range of the input module. Tap to change the range.
L.P.F.:
Displays the low-pass filter setting. Tap to change the filter.
A.A.F.: Displays the antialiasing filter setting. Tap to change the filter.
8.1.3. Sheet Setup
Tap Sheet in the recording settings to display a list of the monitor display and printer waveform sheet
settings.
Tap SHEET1 to SHEET3 to display the channel registered in the corresponding sheet as ON .
The sheet number is displayed for the channels set in other sheets. Tap the channels to display or print
out at the same time to set them to ON .1 Up to 48 channels can be enabled for a single sheet at the
same time, and the current number of selected channels is displayed on the right side of the table.
When the number of channels exceeds 48, set the input of unnecessary channels to OFF or insert
them in another sheet.