A&D RA3100 Omniace, Инструкция по эксплуатации

Страница: 125 / 176

9.Using Optional Modules - 9.6.Remote Control Module (RA30-112)
1WMPD4004444 125
Input module SLOT 9 RA3100 main unit
Common
Settings
Interface
CHB H
L
+24 V
L: Common to each channel
Between each input and the
chassis, to ground
AC, DC 42 V
GND (three pin power cable connection)
3 Pin layout of output connector
Pin
number
Sig
name
Pin
number
Sig
name
Function
A1
START/
STOP OUT
B1 IGND
Measurement signal/stop signal
The L level signal is output while the product is performing
measurement. The START/STOP signal of remote input is
also output.
A2 MARK OUT B2 IGND
Mark
Output the MARK signal of remote input to the MARK
output.
A3 FEED OUT B3 IGND
Feed (idle feeding of recording paper)
Output the FEED signal of remote input to the FEED
output.
A4 PRINT OUT B4 IGND
Print
Output the PRINT signal of remote input to the PRINT
output.
A5
EXT SMPL
OUT
B5 IGND
External synchronization sampling
Output the SMPL signal of remote input to the EXT SMPL
signal output.
A6 TRIG OUT B6 IGND
Trigger
Outputs the TRIG signal of remote input or the trigger
detection signal of this product. This signal enables
synchronization operations.
A7 OSC OUT B7 IGND
OSC signal for AC strain module
This output is used for synchronizing with the AC strain
module installed in another RA3100.
Connector for output signal: DF02R014NA3 (Japan Aviation Electronics Industry)
The A series and B series are complementary. IGND (B series) is the common for A series signals.
IGND is shared with input/output terminals inside the module.
IGND is isolated from the main unit frame (GND).
The plugs (manufacturer model numbers) corresponding to each output signal connector are indicated
below.
Compatible plug: DF02P014F22A1 (soldered type), DF02P014G28A1 (pressure connected type)
4 Maximum rated voltage to ground