A&D RA3100 Omniace, Инструкция по эксплуатации

Страница: 74 / 176

7.Playback Recorded Data- 7.3.X-Y Waveform
74 1WMPD4004444
7.3.2. X-Y Control
(1) Meas. ON:
Enables/disables X-Y measurement.
(2) All pen up:
Tap this key when the X-Y waveform is displayed on the
monitor to pause the X-Y waveform display. This enables
unnecessary waveforms to not be inserted when switching
the monitored input signal, etc.
(3) All clear:
Clears all the X-Y waveform and starts the display again.
(4) Grid ON/OFF:
Switches the grid lines of the X-Y waveform display area on
or off.
(1) (6)
(2) (7)
(3) (8)
(4) (9)
(5)
(5) Update graph (b/w AB):
Displays the Y-T waveform with the playback mode and displays the X-Y waveform with the range
specified by cursors A and B.
(6) CH setup:
Configures the channel settings for waveforms X-Y1 to X-Y4.
Tap this key to switch to the [X-Y channel settings] screen to configure the X axis and Y axis channel
settings for each waveform.
(7) All pen down:
Resumes waveform display when it has been paused with [All pen up].
(8) Dot/Line:
Switches between rendering the X-Y waveform with dots or rendering it with lines.
(9) Single/Quad:
Switches the X-Y waveform display between the single and quad screen display.
X-Y waveform channel setup procedure
Step 1. Waveform selection Step 1. Step 2. Step 3.
Selects waveforms X-Y1 to X-Y4.
When a waveform is tapped it is highlighted and its
state is displayed in the channel table.
Step 2. Axis selection
Select the X axis or Y axis.
When an axis is tapped, the channel specified for that
axis is highlighted and the display changes to [ON].
[X axis] or [Y axis] is displayed for the channel
already set for the other axis.
Step 3. Channel selection
Select the channel.
Tap the channel to set and enable it.
Step 4. When the settings are complete, tap [←] or [x] on the top title bar to return to the original X -Y
waveform display.