53
3D Systems, Inc.
STATUS AND MESSAGE LINES
Messages appear either on the Status line or the Message line. Read both lines together to determine the exact state of the 3D printer system.
The Status line generally indicates current state of the 3D printer system. The Message line shows the action to take to complete a function and
move to the next step.
MESSAGE
CAUSE
ACTION
ABORT
ABORT
button pressed.
Press
YES
or
NO
to cancel the command.
ABORT
ACKNOWLEDGED
You confi rmed an abort command. The 3D printer system is
aborting the current job.
NONE.
BUILD PAUSED
PAUSE
button pressed during the build. The print platform
moves forward and the chamber door and waste drawer
remain locked. When you press the
PAUSE
button during a
build, the 3D printer system completes its current task before
stopping.
Press
PAUSE
to continue.
CLEANING
PRINTHEAD
The 3D printer system is cleaning the build jets.
NONE. (This occurs automatically before
every build.)
CLOSE DOORS
The chamber door is open.
Close
the chamber door.
CONFIRM PLATFORM
CLEAR OR CANCEL
The 3D printer system is prompting you to verify the platform is
clean and clear of obstructions.
Verify the platform is clean and clear, then
press
YES
to continue / press
ABORT
to
cancel.
PRESS PAUSE TO
CONTINUE
The 3D printer system is paused.
Press
PAUSE
to continue /
ABORT
to cancel.
CYCLE POWER TO
CONTINUE
A severe error occurred. The 3D printer system cannot recover
from it and must be switched off.
Cycle power to the 3D printer system. If the
error message occurs again, contact your
Certifi ed 3D Systems Service Provider
DONE REMOVE BUILD
The 3D printer system completed building the current job.
Remove the platform.
HOMING PRINTHEAD
The 3D printer system is initializing the Z-axis prior to building.
NONE
HOMING X - Y
The 3D printer system is initializing the X-axis and Y-axis prior
to building.
NONE
INSTALL PLATFORM
The 3D printer system cannot detect a platform.
Install a clean platform.
NOT BUILDING
The 3D printer system is ready to build.
Press
Start
to build.
OK TO POWER OFF
The 3D printer system completed its internal shutdown procedure
and is ready to be shutdown.
Toggle power switch on 3D printer system
rear panel to the
OFF
position.
NOTE: Before you switch power off, verify
you will not need to build parts again
soon. It can take several hours for the 3D
printer system to warm up after you switch
power back on.
ONLINE/MENU?
The 3D printer system is ready to build.
Press
Start
to build.
PAUSE
ACKNOWLEDGE
The PAUSE button was pressed. The 3D printer system is
acknowledging and complying with the command.
NONE
NOTE: If you press PAUSE during a
print job, the current layer or process is
completed before the pause takes effect.
continued next page
