10
3D Systems, Inc.
PART MATERIAL
VisiJet CR-CL, CR-WH, CF-BK
Shelf life
1
yr.
Climate
Cool, dry area with
adequate ventilation
Storage Class 10
Environmentally
hazardous liquids
Storage Temp
Below 95°F (35°C)
Environmental Conditions
No direct sunlight, heat,
fl ames, or UV energy.
MATERIAL HANDLING AND STORAGE
SUPPORT MATERIAL
VisiJet S500
Shelf life
5
yr.
Climate
Cool, dry area with
adequate ventilation
Storage Class
N/A
Storage Temperature
Below 95°F (35°C)
Environmental Conditions
No direct sunlight, heat,
fl ames, or UV energy.
NOTE: For optimal results, keep stored cartons closed, and do not open until bottle is ready for use.
Always check bottle’s expiration date before loading. Do not load bottles into 3D printer system if they are about to expire. When 3D printer
system detects an expired bottle, it aborts the build and rejects the bottle if the expiration date has expired for support material or more than
one year past the expiration date for part material.
NOTE: When storing material bottles that have been used but still have materials in them, do not place the bottles on their side; stand
bottles in the upright position. Also, in the case where used bottles with materials are removed from the MDM and are still warm, it
must be stored with the cap vented. If the warm bottle is not vented, the wax will contract during cooling and the bottle’s bottom may
become fl at which will prevent re-engagement in the MDM. See “Material Delivery Modules (MDM) and Material Bottles” on page 25
for a description of the MDM.
Support material bottles must be loaded in the left side material delivery module. The part material bottles must be loaded in the right material
delivery module. Before loading material bottles into the 3D printer system, inspect bottles for signs of damage or leakage. Do not load a
damaged or leaking bottle. Dispose of them according to local regulations.
