Upgrades
5-11
4
Slip the ribbon cable out of the cable clamp.
Figure 5-6 shows the location of the cable clamp.
5
Remove the diskette drive from the chassis.
Remove the screw that fastens the diskette drive bracket to the bottom of
the chassis. Figure 5-6 shows the location of the screw.
Slide the bracket toward the rear and lift it and the diskette drive out of the
chassis. The bottom of the bracket has two keyhole slots that fit over
standoffs on the bottom of the chassis. You must slide the bracket far
enough to the rear to lift it off the standoffs.
6
Transfer the bracket from the original diskette drive to the new one.
a
Remove the four screws (two on each side of the bracket) that hold the
diskette drive.
b
Slide the old drive out of the bracket.
c
Slide the new drive into the bracket.
d
Replace the four screws.
7
Replace the bracket in the chassis.
a
Slip the keyhole slots on the bottom of the bracket over the standoffs on
the bottom of the chassis.
b
Slide the bracket toward the front of the chassis until the front panel of
the diskette drive is flush with the opening in the front panel of the
chassis.
c
Fasten the bracket to the chassis with the screw.
8
Slip the ribbon cable back into the cable clamp.
9
Reconnect the ribbon cable and the power wiring harness to the
connectors on the rear of the diskette drive.
Be sure to replace the ribbon cable in its original orientation.
10
Replace the cover, as described in “Replacing the Cover”.
Replacing the
Power Supply
If any component in the power supply module (other than a fuse) fails, you
must replace the entire module.
CS3000BookFile Page 11 Tuesday, October 15, 1996 5:12 PM
