Back Panel
1-11
For information on the serial connector pin assignments, refer to
Appendix A, “Pin Assignments.”
Cable Strain Relief
Each 16-port asynchronous module is shipped with a strain relief
mechanism. This strain relief allows you to secure the connectors that fasten
to your 16-port asynchronous modules.
The strain relief consists of a metal bracket that you secure between the
two serial connectors of a 16-port asynchronous module. The long bar of
the bracket holds the cable connectors in place.
Figure 1-6 shows the back panel of a CS/3000 series server with three
16-port asynchronous modules and cable strain relief mechanisms.
Figure 1-6
Strain Relief Mechanisms
For information on installing the cable strain relief, refer to Chapter 2,
“Installation.”
Optional Ethernet
Interface Modules
The following optional Ethernet interface modules are available for the
CS/3000 series server:
■
Single-port AUI module (10BASE5), 3Com part number 3C5622
■
Single-port RJ-45 (10BASE-T), 3Com part number 3C5623
You must install one of these optional Ethernet interface modules in the
back panel of the CS/3000 series server in order to operate on a network.
CAUTION:
Powering on the server without an Ethernet module can result in
overheating. The warranty is void if this situation occurs.
AUI PORT
J1
PARALLEL PRINTER
INTFC
J4
CONSOLE AUXILIARY
J1 RS-232C J2
• • • • • • • •
• • • • • • •
• • • • • • • • • • • • •
• • • • • • • • • • • •
J15
J14
J12
J13
J10
J11
Cable strain relief mechanisms
CS3000BookFile Page 11 Tuesday, October 15, 1996 5:12 PM
