ZyXEL Communications USG110, User Manual

Page: 513 / 1090

Chapter 20 Web Authentication
ZyWALL USG Series User’s Guide
513
20.4.1 Configuration Overview
These are the screens you need to configure:
• Configure the Zyxel Device to Communicate with SSO on page 513
• Enable Web Authentication on page 514
• Create a Security Policy on page 515
• Configure User Information on page 516
• Configure an Authentication Method on page 517
• Configure Active Directory on page 517 or Configure Active Directory on page 517
20.4.2 Configure the Zyxel Device to Communicate with SSO
Use Configuration > Web Authentication > SSO to configure how the Zyxel Device communicates with
the Single Sign-On ( SSO ) agent.
Figure 371 Configuration > Web Authentication > SSO
The following table gives an overview of the objects you can configure.
Table 177 Configuration > Web Authentication > SSO
LABEL DESCRIPTION
Listen Port The default agent listening port is 2158. If you change it on the Zyxel Device, then
change it to the same number in the
Gateway Port field on the SSO agent too. Type
a number ranging from 1025 to 65535.
Agent PreShareKey Type 8-32 printable ASCII characters or exactly 32 hex characters (0-9; a-f). The
Agent PreShareKey is used to encrypt communications between the Zyxel Device
and the SSO agent.
Primary Agent Address Type the IPv4 address of the SSO agent. The Zyxel Device and the SSO agent must
be in the same domain and be able to communicate with each other.
Primary Agent Port Type the same port number here as in the Agent Listening Port field on the SSO
agent. Type a number ranging from 1025 to 65535.
Secondary Agent Address
(Optional) Type the IPv4 address of the backup SSO agent if there is one. The Zyxel Device and
the backup SSO agent must be in the same domain and be able to communicate
with each other.