ZyXEL Communications Prestige 792H, User Manual

Page: 266 / 437

Prestige 792H User’s Guide
23-2 Internet Access
Table 23-1 Internet Access Setup
FIELD DESCRIPTION EXAMPLE
ISP’s Name Enter the name of your Internet Service Provider. This
information is for identification purposes only. ChangeMe
Encapsulation
Press [
SPACE BAR
] to select the method of encapsulation
used by your ISP. Choices are PPPoE , PPPoA , RFC 1483
or ENET ENCAP .
ENET ENCAP
Multiplexing
Press [
SPACE BAR
] to select the method of multiplexing
used by your ISP. Choices are VC-based or LLC-based .
LLC-based
VPI # Enter the Virtual Path Identifier (VPI) that the telephone
company gives you. 8
VCI # Enter the Virtual Channel Identifier (VCI) that the telephone
company gives you. 35
ATM QoS Type Press [SPACE BAR] and select CBR (Continuous Bit Rate) to
specify fixed (always-on) bandwidth. Select UBR (Unspecified
Bit Rate) for applications that are non-time sensitive, such as
e-mail. Select
VBR (Variable Bit Rate) for bursty traffic and
bandwidth sharing with other applications.
UBR
Peak Cell Rate
(PCR)
This is the maximum rate at which the sender can send cells.
Type the PCR. 0
Sustain Cell Rate
(SCR)= 0
Sustained Cell Rate is the mean cell rate of a bursty, on-off
traffic source that can be sent at the peak rate, and a
parameter for burst-type traffic. Type the SCR; it must be less
than the PCR, unless both are set to zero. 0
Maximum Burst Size
(MBS)= 0
Refers to the maximum number of cells that can be sent at
the peak rate. Type the MBS. The MBS must be less than
65535. 0
My Login Configure the My Login and My Password fields for PPPoA
and PPPoE encapsulation only. Enter the login name that
your ISP gives you. If you are using PPPoE
encapsulation ,
then this field must be of the form user@domain where
domain identifies your PPPoE service name.
N/A
My Password Enter the password associated with the login name above. N/A
ENET ENCAP
Gateway Enter the gateway IP address supplied by your ISP when you
are using
ENET ENCAP encapsulation.
N/A