ZyXEL Communications Prestige 792H, User Manual

Page: 92 / 437

Prestige 792H User’s Guide
5-20 WAN Setup
Table 5-4 Advanced Modem Setup
LABEL DESCRIPTION
Drop DTR When
Hang Up
Select this check box to have the Prestige drop the DTR (Data Terminal Ready)
signal after the "AT Command String: Drop" is sent out.
AT Response
Strings
CLID Type the keyword that precedes the CLID (Calling Line Identification) in the AT
response string. This lets the Prestige capture the CLID in the AT response string
that comes from the WAN device. CLID is required for CLID authentication. Example:
NMBR
Called ID Type the keyword preceding the dialed number.
Speed Type the keyword preceding the connection speed. Example: CONNECT
Call Control
Dial Timeout Type a number of seconds for the Prestige to try to set up an outgoing call before
timing out (stopping). Example: 60
Retry Count Type a number of times for the Prestige to retry a busy or no-answer phone number
before blacklisting the number. Example: 0
Retry Interval Type a number of seconds for the Prestige to wait before trying another call after a
call has failed. This applies before a phone number is blacklisted. Example: 10
Drop Timeout Type the number of seconds for the Prestige to wait before dropping the DTR signal if
it does not receive a positive disconnect confirmation. Example: 20
Call Back Delay Type a number of seconds for the Prestige to wait between dropping a callback
request call and dialing the corresponding callback call. Example: 15
Back Click Back to return to the previous screen.
OK
Click OK to return to the previous screen, then click OK to return to the next previous
screen and click Apply to save the changes.
Cancel Click Cancel to begin configuring this screen afresh.