![background image](http://html1.mh-extra.com/html/zetron/15p/15p_operating-manual_3536660111.webp)
Section 7. Quick Reference
7-11
Field Programming the Maxon HSC-5000 Pager with the Model 15P
1. Start with the Pager ON/OFF Model Selector Switch in the OFF position.
2. Move the Switch to the high position AND during the period when all the segments of
the display are visible, press the R/R (Read/Reset) Button twice. This will display the
pager's current address in the form RRR-CCCCC-SB where RRR is the Roam Mode
Capcode, CCCCC is the Capcode, S is the service block, and B is the beep time. If the
current address does not appear in the display and instead seven dashes are displayed, go
back and repeat steps 1 and 2.
3. Press and hold the R/R (Read/Reset) Button for 10 to 12 seconds until the pager beeps.
The pager is now in the “Learn Mode”.
4. Using the Zetron Model 15P, connected to the Maxon HSC-6000 pager via an RF link or
direct audio input, enter the current capcode of the pager using the keypad, ignoring the
RCC Capcode and beep time. For example: if the current capcode is 000-00121-03, key
the leading digit required, and then SCCCCC (S = Service Block, CCCCC = Capcode),
then the function digits 00 and then the PAGE key. The Model 15 will respond with four
underline characters. At this time enter the new capcode followed by the service block
and a beep time of 3 or less. Enter #, then PAGE and PAGE will appear in the encoder
display while the information is transmitted to the pager.
For example: Enter 12345 03 # PAGE, and the Model 15 transmits the properly formatted
message to the HSC-6000 pager that will make the new capcode 000-12345-03. Verify this
new capcode by repeating steps 1 and 2.
REVIEW: Enter 0 0 00121 00 PAGE 12345 0 3 # PAGE and the old capcode of 000-00121-
03 is replaced with the new capcode 000-12345-03 if the pager is in the learn mode when
this transmission occurs.