Section 5. Programming
5-9
Table 5. PROGRAMMING-5 Programming a Leading Digit for 2-Tone
Prompt
Keystroke Explanation
SEtUP
C and CLEAR
The display indicates that no formats have been programmed. Hold
the C and CLEAR keys down together to enter the programming
mode.
ConFiG
Release keys
Display indicates the encoder is entering the program mode.
diGt=0
0 , ENTER
Selects the leading digit “0” for paging format programming. Pressing
ENTER will accept the value displayed and proceed to the next
prompt.
dELEtE
PAGE
dELEtE is the default message displayed if no format resides in the
leading digit selected. Pressing the PAGE key repeatedly will scroll
through all the installed paging formats available.
2 tonE
ENTER
Pressing the ENTER key will accept the format displayed and proceed
to the next prompt. For this example, 2 tonE is displayed when the
ENTER key is pressed.
tALH=0
1 , ENTER
1 = Voice Message Used. Pressing ENTER will accept the value
displayed and proceed to the next prompt.
COdE=0
1 , ENTER
1 = use 1000 code plans, see Section 7 for 2-tone code plan
information. Pressing ENTER will accept the value displayed and
proceed to the next prompt.
PLN=0
12 , ENTER
Selects the 1000 call code plan Motorola “P”. This uses the Motorola
tone groups 2, 3, 4, and 6.
1St=0
10 , ENTER
Sets the first tone's timing to 1 second (10 x 100-millisecond intervals).
Pressing ENTER will accept the value displayed and proceed to the
next prompt.
GAP=0
0 , ENTER
Sets the Gap timing between tones to zero. Pressing ENTER will
accept the value displayed and proceed to the next prompt.
2nd=0
30 , ENTER
Sets the second tone's timing to 3 seconds (30 x 100-millisecond
intervals). Pressing ENTER will accept the value displayed and
proceed to the next prompt.
diAG=0
0 , ENTER
Disables the use of Diagonal Tone. In any 100 call block of this code
plan that uses the same tone group for both tones, group call paging
will be supported. Pressing ENTER will accept the value displayed
and proceed to the next prompt.
dur= 0
80, ENTER
Sets the diagonal tone duration to 8.0 seconds.
....
Momentary display indicating all parameters are programmed.
diGt=0
CLEAR
After programming the format is completed, the display returns to the
prompt for a leading digit. Other keys can be used for additional
programming at this point. Pressing the CLEAR key exits the
programming mode.
SAVinG
The display indicates the encoder is saving the programming values in
non-volatile memory.
---
The display indicates the encoder is ready for capcode entry. The
number of dashes will depend on the programming and type(s) for
mats used.
