Zero DS 2012, Owner'S Manual

Page: 72 / 120

5-15
32 mm (1.25 in)
Checking The Drive Chain
1. Remove the key from the key switch.
2. Using a ruler, grasp the chain halfway between
the front and rear sprockets.
3. The chain should move 16 mm (.63 in) in either
direction, so 32 mm (1.25 in) of total free play.
4. If the chain’s free play is not within specifications
it will need to be adjusted. See the Drive Chain
Adjustment Procedure on page 5-16.
•
Never place your hand between the chain and
sprockets. Work with the chain only in the middle
between the two sprockets. Failure to do so
could result in serious personal injury.
•
Do not allow any of the lubricant to get on the
brake rotors or brake pads. If the brake rotors or
brake pads are contaminated with lubricant, it will
impair the motorcycle’s ability to stop. This could
result in serious personal injury.
Follow the manufacturer’s instructions for the chain
lubricant you are using; below are the general guide-
lines. Do not allow any of the lubricant to get on the
brake rotor.
1. Turn the wheel backwards slowly and spray the
inside of the chain on the inside of the links.
2. Turn the wheel backwards slowly and spray the
outside of the chain on the outside of the links.
3. Let the motorcycle stand for 30 minutes to allow
the lubricant to penetrate the link rollers.