1-13
SU
SP
E
N
SI
O
N
FA
ST
A
C
E.C
OM
F
S
SU
SP
EN
S
IO
N
FAS
TA
CE
.C
O
M
F
S
IGN
IT
IO
N
OFF
ON
A
A
Transporting
When the front fork is compressed, the built up
pressure must be released to help prevent fork seal
leaks. There is a 3 mm Allen “bleed” screw located
just in front of the rebound adjuster on each fork leg.
This “bleed” screw (A) is used to release the built up
pressure. Loosen the screw slowly, but do not
remove. Once all the air is out, tighten the bleed
screw.
When the fork is released, with no weight on the front
tire, the screw must be opened again to allow for
stabilization. Ensure that the screw is tightened before
riding.
Use two ratchet straps in the front and two in the
rear. The tie down straps should be at a 45° angle
from the motorcycle. Follow the manufacturer’s
instructions for the ratchet straps you are using.
It is recommended that the motorcycle be tied-down
using ratchet straps. Place the ratchet straps around
a frame contact point. Soft straps must be used to
prevent scratches or other damage.
Summary of Contents for DS 2012
