Zero DS 2012, Owner'S Manual

Page: 47 / 120

4-10
Charging The Power Pack
WARNING: Charge the Zero power pack with the Zero
charger.
It is possible for lithium ion cells to overheat and fail.
It is recommended to charge in a location that is
away from combustible materials and in a well-
ventilated area. If charging your Zero motorcycle
outdoors, avoid charging in the rain.
The maximum power pack internal charging
temperature is 52°C (125°F). If the power pack’s
internal temperature is over 52°C (125°F), it will not
accept a charge until it is moved to a cooler location.
Also, if the power pack has just been run hard, it may
internally be above 52°C (125°F) even if the ambient
temperature is lower.
C. 100% Charge
The 100% Charge LED is a green indicator. If it is on
solid, the charging is complete and the charger will
enter maintenance mode. If it is flashing, the
absorption phase is complete and the charger is in
finish phase.
D. AC ON
The AC ON LED is an amber indicator. If it is on
solid, the AC power is good. If it is flashing, the AC
voltage is low. Check for proper voltage, and if an
extension cord is being used, verify that it is of the
correct length. Maximum length is 7.6 m (25 ft.)
12-AWG.
E. Fault
The Fault LED is a red indicator which indicates
there is a charger error. If it is flashing, reset the
charger and see section 6, Troubleshooting.