Zero DS 2012, Owner'S Manual

Page: 79 / 120

5-22
Cleaning
To prolong the life of your motorcycle it should be
washed periodically. Regular cleaning, using correct
methods, is an important factor in maintaining the
value of your motorcycle. It also ensures that safety-
relevant parts remain in full working order.
CAUTION: After cleaning and before starting your
journey, always test the brakes.
2. Pull the old bulb straight out from the socket.
3. Push the new bulb into the socket, and push the
socket into the headlight.
If tar, bugs, or other similar deposits have
accumulated, wash them off as soon as possible. Do
not use high pressure or steam cleaners; they can
cause water intrusion of bearing, seals, and electrical
components. Avoid spraying water of great force
around the instrument panel, power pack, or
controller. Avoid using strong acidic wheel cleaners,
especially on spoked wheels. If such products are
used on hard-to-remove dirt, do not leave the cleaner
on the affected area any longer than instructed. Also
thoroughly rinse the area off with water, immediately
dry it, and then apply a corrosion protection spray.
WARNING: Improper cleaning can damage electrical
components, cowlings, panels, and other plastic
parts. Use only a soft, clean cloth or sponge with
mild detergent and water to clean plastic.
Do not use any harsh chemical products on plastic
parts. Be sure to avoid using cloths or sponges
which have been in contact with strong abrasive
cleaning products, solvent or thinner, fuel (gasoline),
rust removers or inhibitors, brake fluid, antifreeze or
electrolyte.