MAXinBOX FC 0-10V VALVE
http://www.zennio.com
Technical Support:
http://zennioenglish.zendesk.com
5
Outputs (2) and (6)
:
output ports for the insertion of the stripped cables of
the systems being controlled by the actuator (see sections 2.3, 2.4 and 2.5).
Please secure the connection by means of the on-board screws.
For detailed information about the technical features of the device and for safety
instructions and on the installation process, please refer to the
Datasheet
bundled with
the original packaging of the device and also available at
www.zennio.com
.
1.3
START-UP AND POWER LOSS
During the start-up of the device, the Prog./Test LED will blink in blue colour for a few
seconds before MAXinBOX FC 0-10V VALVE is ready. External orders will not be
executed during this time, but afterwards.
Depending on the configuration of the fan coil control module, some specific actions
will also be performed during the start-up. For example, the integrator can set whether
the outputs should switch to a particular state and whether the device should send
certain objects to the bus after the power recovery. Please consult the next sections of
this document for further details.
On the other hand, when a bus power failure takes place, MAXinBOX FC 0-10V
VALVE will interrupt any pending actions, and will save its state so it can be recovered
once the power supply is restored. Moreover, all relay outputs will remain open, for
safety reasons.
