MAXinBOX FC 0-10V VALVE
http://www.zennio.com
Technical Support:
http://zennioenglish.zendesk.com
4
Manual operation / supervision
of the relay outputs and the 0-10 VDC
signals through the on-board pushbuttons and LEDs.
1.2
INSTALLATION
MAXinBOX FC 0-10V VALVE connects to the KNX bus through the on-board KNX
connector.
Once the device is provided with power from the KNX bus, both the individual address
and the associated application program may be downloaded.
This device does not need any additional external power, since it is entirely powered
through the KNX bus.
Figure 1
MAXinBOX FC 0-10V VALVE.
The main elements of the device are described next.
Prog./Test pushbutton (8)
:
a short press on this button sets the device into
programming mode, making the associated LED (5) light in red.
Note
:
if this button is held while plugging the device into the KNX bus, the
device will enter into safe mode. In such case, the LED will blink in red every
0.5 seconds
.
1. Multi-Purpose Inputs.
2. 0-10 VDC Outputs.
3. Output Status LED Indicator.
4. Output Control Button.
5. Prog./Test LED.
6. Binary Outputs.
7. KNX Bus Connector.
8. Prog./Test button.
1
8
3
5
6
2
4
